The H.Plus-504 horizontal machining center is equipped with a rotary indexing table (B-axis) standard, driven with a direct-drive motor with a maximum feed rate of 100rpm. In addition, Matsuura’s Dynamic Clamp System and Automatic Acceleration and Deceleration Control intelligently contribute to a shorter cycle and indexing time.
Expandable automatic tool changer and automatic pallet changer options enable extended unmanned operation. A maximum 330 tools can be stored in a matrix-type magazine, and up to six pallets can be stored in a floor-pallet system.
The NC Matsuura G-Tech 31i is installed with the Matsuura Intelligent Meister System and uses an operation system with a 15" touch screen that improves operability, reduces non-cutting time, and facilitates setup, operation, and maintenance while saving labor and energy.
Matsuura Machinery USA Inc.
Explore the November December 2016 Issue
Check out more from this issue and find your next story to read.
Latest from Aerospace Manufacturing and Design
- Boeing strike ends after more than 7 weeks
- Siemens acquires Altair Engineering
- Mitutoyo's Metlogix M3 with the Mitutoyo Quick Image Vision System
- IMTS 2024 Booth Tour: SW North America
- Eve Air Mobility receives $50 million
- Starrett's AVR400 vision metrology system
- IMTS 2024 Booth Tour: HAINBUCH America Corporation
- Applications open for 2025 EAA Aviation scholarships